Nose skins and traling edge (3hr 30m)

Started out today by drilling through the pilot holes in the top skin into the spar. This allowed us to cleco the nose skins in place on the spar.

and then drill all the holes in the ribs and nose skins to A4 rivet size.

After this we positioned the two trailing edges onto the rear channel. We had a bit of trouble with this as the strut fitting was kind of in the way (in the video they leave it off until later) but after some messing around it went on fine. We drilled a couple of holes to keep the edge attached to the bottom skin.

and eventually drilled pilot holes the full length of the trailing edge.